Figured I would start a project thread...
1991 Gambler Intimdator Dale Earnhardt edition
1998 Merc 200 efi
Project started
https://www.speedmastermarine.com/pr...0-outboard-ecu
Is there someone here with deep pockets ready to try this? Or is this
You never know these days,
https://www.outboardglobalstore.com/oxe-diesel
ABOUT US
Welcome to Outboard Global Store ,
https://www.caudwellmarine.com/
Last Post By: CUDA Yesterday, 10:47 PMI laugh every time I see this.
I have always been fortunate enough to have a cottage, now a home, on the water. It makes boating much more accessible. For example, yesterday when
Last Post By: FUJIMO Yesterday, 08:02 PMHi,
Bought an Exocet 23 (piranha hull with phantom deck) and I put a 300 R, 1.75 TM, on it (not an SM, no hydraulic jackplate on it).
Original 23' outboard, 8' Beam, 2018 Mercury 400 on stainless marine setback.
20" lower with fat shaft
Boat has small cabin,
Need a pair of 280 stock heads. 150 psi or less.
Thank you
Was thinking I could run these I have run worse in the past. I don’t want to shave these further they are 34cc which is what I want. I do have some 38’s
Last Post By: LakeFever Yesterday, 05:16 PMwhat triggers the temp alarm to go off ? i have a cylinder temp sensor, wire runs externally up to dash gauge, in harness have a tan and tan/blue hanging
Last Post By: KIRCHNER Yesterday, 04:27 PMI read somewhere that the tension on the belt should be 70 inch - lbs. What is the correct way to check... set the torque wrench to 70 inch - lbs. then
Last Post By: 4Speed Yesterday, 03:48 PMCurrently purchasing a 1990 135 horse Mercury v-6 that supposedly has low compression in hole number 6, owner says cylinder may be scuffed. Is it possible
Last Post By: tlwjkw Yesterday, 03:42 PM
What counter rotating gear cases can fit the Mercury 150 4 strokes
Thread Starter: Mini MaxI am designing a 2021 Switzer wing clone for Mercury 150 4 strokes.
Last Post By: Mini Max Today, 05:19 AMThe problem is, 20 " legs are only RH rotation and 2;1 gears. You